The fruit shell is used as raw material, which is solidified and extruded into high-density biomass particles by pretreatment and processing. The pellets fuel can be used for burning, barbecue, and fireplace heating, and the combustion efficiency is over 80%; and the sulfur dioxide, ammonia nitrogen compounds and dust generated are less.
Jiangsu Liangyou Zhengda Co., Ltd is specialized in manufacturing biomass pellet fuel production machinery, we can supply customer: biomass pellet production line which take wood log, sawdust, shavings as raw material, biomass pellet production line which take building templates, woodworking scrap as raw material, biomass pellet production line which take maize stalk, wheat stalk, straw and others as raw material, biomass pellet production line which take fruit shell, fruit residue, palm and others as raw material, biomass pellet production line which take Crop waste, sludge, coal and others as raw material. FDSP will customize kinds of complete project solutions to meet customers' different needs.
Now we take the case of 1t/h fruit shell and waste biomass production line, make introduction based on process diagram and each process as follows:
There are mainly shells or residual of fruits like nuts shells, apple residual and peanut shells, and so on.
Craft procedure drawing:
Process diagram of complete fruit shell and fruit pulp pellet engineering flow process:
Grinding section → Pelleting section→ Cooling & Bagging section
Flow Process introduction:
After the shell is grinded by hammer mill, then it is granulated. The processed finished granules are 6-10mm in diameter, and the granules are cooled and packaged for transportation and sale. When the fruit shell and fruit pulp pellet complete project is with 1 ton per hour capacity, the total power of the equipment is about 145kw, and the workshop covers an area of 800m2, which contains raw material warehouse and finished product warehouse. The whole line is compact in design, reasonable in structure and meets environmental protection requirements. And can be customized design according to customer requirements.
Process sections are as follows :
There is no dust discharge in this process. After grinding, it is transported and pneumatic transmission by the fan suction air pressure. The hammer mill is a water droplet type structure; the hammer mill rotor can be operated in forward and reverse directions to improve the service life of the hammer blade; the direct transmission mode of the motor is adopted.
Grinding equipment: MFSP56*40, power 37kw, design with 1T/H output.
The diameter of biomass pellet is 6-10mm optional, and the biomass pellets have the characteristics of high calorific value, no pollution and low ash content, which can be widely used in biomass power plants, biomass steam boilers, household fireplaces, drying furnaces and biomass gasifier.
Pellet mill: MZLH420, main motor power: 90kw, power of forced feeder: 0.75kw, design with 0.8-1.2T/H output.
Cooling & Bagging section:
used to reduce pellets temperature and decrease pellets moisture, pellets temperature is not higher than ambient temperature 5 ℃ after cooling and the pellets moisture around 8-10%.
Cooling equipment: MKBZ120, design with 1-2t/h output.
The process can be optimized according to different customer needs:
1. Dryer will be needed if the moisture of sawdust is higher than 20%, the moisture of sawdust should be dried to 13-15% by dryer before pelleting.
2. The packing machine can be adjusted according to customers' requirement for bag size. Bulk or silo storage is also optional.
Marketing Center: +86-519-6826 6288 /+86-17705145508
Engineering Center: +86-519-6826 6588 /+86-15206145688
South Factory: No.6 Chenyang Road, Zhongguancun Science & Technology Industrial Park, Liyang, Jiangsu, China
North Factory: No.558 Hongsheng Road, Zhongguancun Science & Technology Industrial Park, Liyang, Jiangsu, China